Maxxair Vent Cover 00-933066

MaxxAir RV Roof Vent Cover

Protect your camper's interior from rain damage while allowing your MaxxAir RV roof vent to remain open. Allows constant air flow through your RV to stop heat buildup. Musty air, heat, smoke, and cooking odors escape while rain stays out. Features MaxxAir Vent's exclusive Zero-Leak™ Mounting System that eliminates the need to drill any holes in your RV’s roof surface. Maxxair Vent Cover mounts to most popular 14" x 14" standard roof vents. Six-year limited warranty.

Details:

• Protects Your RV's Interior From Rain
• Constant Airflow Prevents Heat Build-Up, Lets Musty Air, Smoke And Cooking Odors Escape
• Proven, Super Tough One Piece Design
• Made Of High Density Polyethylene With Maximum UV Protection
• Fits Over Most 14 Inch X 14 Inch Standard Roof Vents. Installs Easily!
• Limited 6 Year Warranty
• Length (IN): 19-1/4 Inch
• Width (IN): 18-1/2 Inch
• Color: White

Included:

• Roof Vent Cover
• Mounting Hardware

Installation:

1. Place the MaxxAir Camper Roof Vent Cover over the roof vent with the louver area facing the rear of the vehicle. After verifying that the MaxxAir RV roof vent cover (black) is centered over the roof vent, trace on your camper roof (with a pencil) the location of the slots in the MaxxAir Vent Cover's mounting flange.


2. Position a MaxxAir RV roof vent mounting bracket on your roof so that the slot in the bracket intersects one of the slot locations traced on the roof. For maximum strength place the MaxxAir mounting brackets as close as possible to the outside corner of your existing camper roof vent frame.


3. Mark the location of the screw hole in the bracket onto your RV roof vent frame. Drill through the camper roof vent frame using a 3/16" dia. drill bit. Place one of the carriage bolts upward through the slot in the bracket and fasten the MaxxAir RV roof vent bracket to the RV roof vent wall using the small bolt provided. The small washer, lock washer, and hex nut should be placed on the inside of the roof vent frame wall. Install two MaxxAir brackets on each side of your RV roof vent as shown in the drawing.


4. Place the MaxxAir RV roof vent cover (black) on the four upward pointing carriage bolts and fasten using the large washers and hex nuts provided. You may have to push the head of the carriage bolt up into the bracket slot to prevent the carriage bolt from turning during tightening of the hex nuts.

PLEASE NOTE: A slight air gap between the base of the MaxxAir RV Roof Vent Cover and the RV roof after installation is normal and permits condensation to escape




MaxxAir RV Roof Vent Covers Also available in the following colors:

• 311922 - Smoke
• 311939 - Almond
• 312127 - Black
• 312135 - Champagne